Android Studio is one of the best IDEs for Android apps development, but with legacy computers, it is very slow. To run it on a Dell Vostro 3546, here's what I had to do. Upgrade hardware Minimum RAM required is 8 gb. The laptop came with 4 gb DDR3 1600 Mhz RAM which was slow, … Continue reading How to improve speed of Android Studio on a legacy computer
Open a terminal window and enter the following to find out technical information of an SSD installed in the computer using Linux. $ sudo hdparm -i /dev/sda <enter> /dev/sda:Model=CT500MX500SSD1, FwRev=M3CR043 Visit https://www.crucial.in/support/ssd-support/mx500-support to check if there is a firmware upgrade for the SSD.
The humble Dell Vostro 3546 is an old laptop from 2014, which came with an Intel 4th Generation 4210U processor, 1 TB SATA 5400 rpm hard disk and 4 GB DDR3 (low voltage) 1.35V RAM. It worked fine till now even when it ran Linux Mint 20.3 with Blender 3D. However, everytime an Android app … Continue reading How to install Linux Mint on Crucial MX500 SATA SSD drive on Dell Vostro 3546 laptop after BIOS upgrade
Decrease swappiness whereby the use of swap is curtailed$ cat /proc/sys/vm/swappiness <enter>returns the value of swappiness which is 60 initially. Make this 20 as follows:$ sudo xed /etc/sysctl.conf <enter>Add a line to the end of the filevm.swappiness=20Save the file. Disable Java in LibreofficeOpen Libreoffice Writer.Go to Tools -> Options -> Advanced -> Java OptionsUncheck Java … Continue reading How to improve speed or performance of Linux Mint XFCE on old computer
After upgrading the Dell Inspiron 5570 laptop to Windows 11, the big problem is the speed of the laptop. It deteriorates to the extent that it takes almost 5 minutes to boot. Each click on the desktop to open an app takes almost 30 seconds. With this performance, the laptop is virtually useless. The laptop … Continue reading Dell Inspiron 5570 laptop too slow with Windows 11. Upgrade to M.2 PCIe NVMe SSD
Got a new PCIe NVMe SSD device? It starts lagging after a few months of use on Linux Mint and to optimize it, do the following after opening a terminal window $ journalctl | grep fstrim.service <enter>This will display when the TRIM was last executed. It normally does this once a week. Verify when the … Continue reading There’s something about TRIM in LinuxMint or Ubuntu Linux (Speed up SSDs)
Android Studio works quite slow with a normal SATA Hard Disk Drive (HDD), on a computer. To overcome this, there are a few solutions, including waiting for the good folks at Google to release another efficient version, or if you are seriously into Android development, then you can augment the hardware of your computer by … Continue reading Select and set up a Crucial M2.2280 NVMe PCIe SSD